Machine Overview
USED 8 ½” X 27” HEY No 3 CNC AUTOMATIC FACING AND CENTERING MACHINE
Serial No. 2824-1001
FEATURES
- Maximum work length: 27”
- Maximum diameter held in vises: 8 ½”
- Maximum cutter diameter: 6.3” (160 mm)
- Spindle speed range: 200 – 1200 R.P.M.
- Feed stroke of heads: Total – 3”, Feed – 2”
- Feed box ratio: 165:1
- Feed rates-infinitely variable: 0 to .018”/rev.
Equipped with:
- Full machine enclosure w/ Light Guard
- Automatic retracting end stop
- 15 HP AC spindle motors 3/60/230-460 VAC
- Self centering air vises – variable pressure
- Automatic/manual mode selection
- (2) Cutter Body Heads
- Heidenhain DRO on LH head
- AC feed servo motor
- Coolant System
- Trabon automatic lube system
- Worklight
- Chip Conveyor
Electrical controls:
- Allen Bradley Panelview 900 LCD display and controller
- AB Model 1336 constant torque AC spindle drives for individual motor control
- AB Model 1394 AC Servo control system for feed/rapid drive
- AB SLC 5/04 programmable controller with memory card and software
- Electrics: 415 Volt, 3 Phase, 50 Cycle
- Approximate floor space: 12’ L X 76” deep X 92” high
- Approximate weight: 8,000lbs.
DISCLAIMER
NB.The above information has been obtained with care to the best of our ability. It is given in good faith, but its accuracy cannot be guaranteed. Accordingly, it does not form a representation or constitute a contractual term.
Prospective purchasers are advised to check any vital details.
Complete Health and Safety Act, April 1st 1974: It is not reasonably practical for ourselves as suppliers to ensure that for your application the goods comply with the requirements of the act with respect to guarding etc.
We would like to remind prospective purchasers to ensure that a guarding specialist or their own health and safety officers inspect the goods prior to use.